Flooded City by Forge Labs
Something terrible has happened and the city is in ruins. When trying to gather your thoughts it seems you aren't too safe yet as the water levels are rising. The water is full of terrific creatures that can tear you apart. What will you do to survive the rising water and the creatures within?
Notice!
To add the rising water levels you will for now have to use Worldedit.
Please note that this is a very demanding process. This process replaces millions of blocks at a time. It is not recommended for low end hardware.
-
Type in the following in chat //pos1 1174,62,903. This will set the first position to be one of the corners of the city.
-
Then, type //pos2 -228,x,-70 where x represents the amount you want to raise the water level by. For example if you wanted to raise the water level by 10, you'd replace x with 72. This is because we have added 10 to the current water level value, which is 62.
-
Finally, in chat you'll want to enter the command //replace 0 water. It will take some time depending on your PC, but you should notice an increase in the water level.
-
When raising the water level again, you'll want to adjust the y value in both position commands to ensure that not you're covering blocks you've already filled. For pos1, set the y value to be the y value of pos2, which would be 72. For pos2, you'll want to set the y value to be this new y value plus however many blocks you want to raise the water level by. If we wanted to do 10 again, we'd do 82.
And that's it! Repeat this process every 10 days if you want the water level to increase regularly.
🔬 World used
